DIY Wind
The No-Nonsense Beginner's Guide to Two PVC Wind Generators
Short it in a storm. Never let it run free.
A small wind turbine is two things: a battery charger, and a spinning blade that can hurt you. This manual builds the small one first, so you learn the brake, the yaw and the battery before you ever cut a bigger blade.
You'll learn how to:
- Bench-test a permanent-magnet motor with a drill, and reject one that will never charge
- Size a first rotor with original worked numbers: about 1.2 m across, three blades cut from thick-wall 6-inch PVC
- Draw, cut, drill and balance your own blades, with no copied drawings
- Build the hub, the tail and a greased yaw that can't lift off
- Wire it with a blocking diode, a fuse at the battery and a shorting brake you can hit with a fist
- Raise a hinged, guyed tower with a rope or winch, with nobody climbing and no lines in the fall zone
- Step up to a larger rotor with a proper permanent-magnet machine or a car alternator, including why shorting a stock alternator destroys its diodes
The safety chapter comes first: blades and cold-cracked PVC, runaway rotors, towers and battery hydrogen. There's no grid tie, and the house wiring stays out of it. Estimates are marked [EST], checks are marked [verify].
For off-grid beginners, cabin owners and makers who want a charger that stops on command. Book 4 of the No-Nonsense DIY series.
Book Info
No download link available yet. You can .
Related Books
Similar recommendations you might enjoy