Mathematics for HVACR 2026-2027
A Step-by-Step Approach to Fractions, Formulas, and Field-Ready Calculations for Trade Technicians
Why does a technician who can diagnose a failing compressor by ear still freeze up at a fraction on a tape measure?
Mathematics for HVACR 2026-2027 is a step-by-step trade-math primer written for HVACR apprentices, trade-school and community-college students, and working technicians who need a reliable field-math reference rather than another abstract classroom workbook. It closes the gap most trade-math texts leave open: the moment a formula is introduced, this book pairs it immediately with Featuring The Field Calculation Decoder, a running feature that decodes the math skill just taught into the exact field task, gauge reading, or part it unlocks. The book moves in one continuous arc, from whole-number and fraction fundamentals through algebra, geometry, and trigonometry, and then directly into the applied electrical, refrigeration, airflow, and business calculations a technician performs on an actual service call or at a fabrication table.
Inside, You Will Find:
A complete foundation in whole numbers, fractions, decimals, percentages, ratios, and unit conversion, taught entirely through HVACR measurements and layouts rather than generic word problems.
Algebra, geometry, and trigonometry built specifically around formula rearrangement, duct and sheet-metal layout, and pipe and duct offset fabrication.
Full Ohm's Law, circuit, and motor electrical calculations, including real power, power factor, and full-load versus locked-rotor amperage.
Pressure, vacuum, and temperature conversion calculations, including superheat and subcooling, built around the gauge and instrument readings technicians take every day.
Refrigeration and thermodynamic calculations covering tonnage, refrigerant charge, the refrigeration cycle energy balance, and EER/SEER/COP efficiency comparisons.
Psychrometric and airflow calculations, including sensible and latent heat, CFM and duct sizing, and the fan laws.
A complete applied closing chapter chaining load calculation, equipment sizing, duct design, and job-costing math, including markup, margin, and fully burdened labor rate.
Every calculation presented in mandatory Step-by-Step worked-example format, with the reasoning behind each step written out in full, never a bare symbolic answer.
The Field Calculation Decoder Index, a complete cross-referenced compendium of every Field Calculation Decoder instance in the book, organized by math skill, by field system, and by chapter.
This is a calculation reference and skills-building text, not an exam-prep workbook -- it contains no end-of-chapter problem sets or practice questions, only complete, fully worked calculations a technician can trust and reuse. Keep it on the bench, in the service truck, or on the desk through an entire apprenticeship program: every time a formula shows up again on a service call, the field task it was always meant to decode is still right there next to it.
Book Info
No download link available yet. You can .
Related Books
Similar recommendations you might enjoy